Tuesday, May 3, 2011

Taking apart a Mac Book Pro 15” Battery Pack. Part 1.

Had a battery pack with bad life, pack could still hold a charge, but the runtimes were seriously degraded (1hrish). Decided to re-new the cells instead of throwing away and buying an entirely new pack.

Not much information on the net about people doing this. DO NOTE THAT THE CELLS ARE LITHIUM POLYMER TYPES, PUNCTURING AND/OR DAMAGE TO THEM CAN/WILL CAUSE A FIRE. Still decided to do it though.

To expose the cells. You’ve gotta remove the top aluminium sheet that’s mounted with a very sticky tape. Start at the corners and go slow, applying some solvent (used IPA for this, seemed a good idea), there’s a thin metal cover between this and the cells, so you shouldn’t be able to start a fire unless you’re seriously using a lot of force. The button and LEDs are not part of the cover. (Button is simply a little metal thing that extends all way down into the controller/protection PCB.)

30042011026

With the cover out you’ll see yet another metal plate, lift the corners and work your way around it’s mounting tabs. There might be some adhesive on the tabs, gently get those off.

30042011027

With that out, next gently remove the little cover just above the power connector, doing this will free the board and cells enough to get them to move. Then with gentle persuasion, guide the cells and board out.

30042011024

30042011025

Next up in this series, replacing and then finally putting the pack together.

3 comments:

  1. can't find the putting together pages

    ReplyDelete
  2. I didn't take pictures of the putting together process, essentially it's the reverse of taking it apart.

    I used some double sided tape to hold everything together and make dis-assembly the next time easier.

    ReplyDelete
  3. What is the specification of the cells inside? Is it easy to find and change them once the pack is opened?

    ReplyDelete